A-61677 December 2013 4-3
Cleaning the separation
module
The separation module should be removed from the scanner for best
cleaning results.
1. Push the separation module up to snap out and lift it out of position.
2. Manually rotate and wipe the separation module tires with a roller
cleaning pad.
3. Inspect the separation module.
If the separation module tires show signs of wear or damage,
replace the tires or the separation module. See “Replacement
procedures” for more information.
4. Insert the separation module by aligning the tabs with the slots and
snapping it into position.
To Next Page
Loading...
