A-61602 January 2008 23
The documents will be scanned and displayed in the Scan
Validation Tool dialog box.
NOTE: If the scanner is in power saver mode, a message will be
displayed that the lamps need sufficient time to warm up.
Scanning will proceed when the lamps are ready.
After the images have been displayed, your scanner installation
verification is completed.
9. Click the Close box to exit the Scan Validation Tool.
Viewing test images The images you scanned can be found in the TWAIN folder on the C
drive. Files will be named using the following naming convention:
image0000001A.jpg is a front image; image0000001B.jpg is a back
image. Double-click on this file to open and view the captured image.
Because factory default settings were used, the image may not be
optimized to meet your needs.
When testing has been completed, delete the test images.
Application software Some scanning applications are available on the CDs packed with your
scanner.
You may also use other capture applications. See the User’s Guide
provided with these applications for instructions on how to use the
software.
To Next Page
Loading...
