14 A-61730 August 2012
• Go to the Home menu and press the LEFT ARROW key until you
reach the Lamp Replacement menu.
• If you replaced the front lamps only or both the front-page and
back-page lamps, press the F1 key [FRONT]. Press the F1 key
[YES]. A Calibrate Front Camera message will be displayed for
several seconds, followed by the Front Lamps Reset message.
Press F1 key [CONTINUE].
• If you only replaced the back-page lamps, press the F2 key
[BACK] Press the F1 key [YES]. A Calibrate Back Camera
message will be displayed for several seconds, followed by the
Back Lamps Reset message. Press F1 key [CONTINUE].
• Press the CLEAR key to return to the Home menu.
• After lamp replacement, the camera calibration icon will flash,
indicating the need to recalibrate the camera to the new lamp
levels. See the section entitled, “Calibrating the cameras” for
more information. For best results, after lamp replacement,
calibrate the cameras immediately (ignoring the 40-minute warm-
up period), and then re-calibrate after the 40-minute warm-up
period has occurred.
15.Boot up the host PC.
To Next Page
Loading...
