20 A-61730 August 2012
10.Slide the new separator roller sleeve onto the brake assembly. The
separator roller sleeve will only slide on in one position onto the
brake assembly.
11. Put the new spacers on each end of the separator roller assembly.
12.Slide the new retaining o-rings onto each end of the separator roller
assembly.
13.Lower the auto/manual feed lever to the ‘A’ position.
14.Open the separator roller access door.
15.Carefully place the separator roller assembly into the separator
cradle. The separator assembly can only be placed in the separator
cradle in one direction. The keyed end should be on the right side of
the scanner when inserted into the separator cradle.
16.Once the separator roller is placed back in the separator cradle,
lightly push down on it to ensure it is located properly.
17.Replace the skimmer assembly.
18.Close the scanner transport cover.
19.Power on the scanner.
20.Boot up the host PC.
Supplies and
consumables
Contact your scanner supplier to order supplies or go to:
www.scannerstore.kodak.com.
NOTE: Items and catalog numbers are subject to change. For the most
up to date list of supplies and consumables go to:
www.kodak.com/go/scannersupplies.
Supplies/Consumables CAT No.
Skimmer Assembly Kit 156 9128
Roller Assembly 870 4801
Lamp Assembly 128 9610
Glass Transport 147 3669
Separator Roller Kit 809 0300
Kodak Digital Science Roller Cleaning Pads 853 5981
Staticide Wipes for Kodak Scanners 896 5519
Tech Wipes 165 1975
Black Ink Cartridge
135 5155
Camera Calibration Kit
157 0415
To Next Page
Loading...
