A-61730 August 2012 11
Software download The control panel contains a Software Download menu which is used to
receive new control firmware. If you must download new control
firmware, contact Technical Support.
NOTE: If the Download new software menu is started by mistake and
no actual download has begun, it is safe to cycle scanner power
(shut down the host PC first; then power the scanner off and
then back on). The scanner will reset itself and power up
normally.
Cleaning the
transport area
As the transport assembly components become dirty, they may feed
documents erratically or skew the documents as they enter the
scanner. To prevent erratic feeding, clean the transport section about
once a week, or as needed.
1. Remove all documents in the ADF and exit tray.
2. Open the document feed guides to the maximum width.
3. Press the CLEAR key to return to the Home menu.
4. Press the CLEANING MENU key located on the control panel.
5. Press the F1 key [START] to start the transport.
6. Place one of the transport path cleaning sheets in the ADF and
lower the skimmer. The sheet will be pulled through the transport
and deposited into the exit tray.
7. Remove the sheet from the exit tray and run it through the transport
again.
8. Remove the sheet from the exit tray and turn it over.
9. Repeat steps 6 through 8.
10.Press the STOP key and then the CLEAR key.
11. Discard the used transport cleaning sheet.
To Next Page
Loading...
