A-61730 August 2012 7
Cleaning the back
camera glass cover
• If you have a simplex scanner, proceed to the section entitled,
“Calibrating the cameras”.
• If you have a duplex scanner, follow the instructions below for
cleaning the glass cover. The glass cover is not the same as the
glass flat.
For best results:
• Do not re-use Tech Wipes. Doing so may re-introduce dust from
previous cleanings.
• Tech Wipes should not be sprayed with any type of cleaner.
The back camera glass cover is located directly beneath the bottom
lamp assembly and can be easily accessed for cleaning when the
bottom lamp assembly and glass flat is removed from the scanner.
Dust on the glass cover can cause streaks or make the image fuzzy;
therefore, the glass cover should be cleaned frequently.
1. Turn off the scanner.
2. Open the scanner transport cover.
3. Open the scanner’s side access panel.
CAUTION: The lamp assembly may be hot! After the scanner has
been powered off, allow the scanner lamps to cool
approximately 5-10 minutes before continuing.
To Next Page
Loading...
