2 A-61730 August 2012
5. Press the F3 key [NEXT] to view front lamp hours used.
6. Press the F3 key [NEXT] to view back lamp hours used.
7. Press the CLEAR key to return to the Home menu.
Code revision
numbers
The Code Revision Numbers menu displays the hardware and software
revision numbers for various parts of the system.
To review the code revision numbers:
1. From the Home menu, press the RIGHT ARROW key until you
reach the Code Revision Numbers menu.
2. Press the F3 key [NEXT] to scroll through the list of devices that
report a software revision number. The number and type of revision
numbers displayed will depend on available scanner options.
3. Press the F3 key [NEXT] to view the scanner firmware revision
number.
4. Press the F3 key [NEXT] to view the feeder revision number.
5. Press the F3 key [NEXT] to view the front IJPM (imprinter) revision
number (where applicable).
6. Press the F3 key [NEXT] to view the back IJPM (imprinter) revision
number (where applicable).
7. Press the F3 key [NEXT] to view the page entry sensor revision
number.
8. Press the F3 key [NEXT] to view the page exit sensor revision
number.
9. Press the F3 key [NEXT] to view the operator interface revision
number.
10.Press the F3 key [NEXT] to view the EGSA software revision
number.
11. Press the F3 key [NEXT] to view the EGSA hardware revision
number.
12.Press the F3 key [NEXT] to view the EGSA FPGA revision number.
13.Press the F3 key [NEXT] to view the EGSA CPLD revision number.
To Next Page
Loading...
