4 A-61730 August 2012
Cleaning procedures Cleaning your scanner and performing preventative maintenance on a
regular basis is required to ensure the best possible image quality.
Some document types generate more paper dust and debris and may
require more frequent cleaning.
Before cleaning your scanner or replacing consumables, review the
following information:
• When cleaning rollers/tires, allow the rollers/tires to dry completely
before scanning.
• Use only the recommended cleaning supplies.
• Do not use cleaners in confined areas, use with adequate
ventilation.
• Do not use cleaners on hot surfaces. Allow surfaces to cool to
ambient temperature before use.
• Do not use canned/compressed air.
• Do not use flammable compressed aerosols on or around the
scanner.
• In addition to the recommended cleaning supplies, you may use a
vacuum cleaner to remove debris from the scanner.
• Staticide wipes contain isopropanol which can cause eye irritation
and dry skin. Wash your hands with soap and water after
performing maintenance procedures. Refer to the Material Data
Safety Sheet (MSDS) for more information. The MSDS is available
on the Kodak web site at www.kodak.com/go/MSDS.
NOTE: To access the MSDS, you will need to provide the catalog
number of the supply. See “Supplies and Consumables”
later in this document for catalog numbers.
• The roller cleaning pad contains sodium lauryl ether sulfate and
sodium silicate which can cause eye irritation. Refer to the MSDS
for more information.
To Next Page
Loading...
