18 A-61730 August 2012
7. Snap the top housing cover back onto the lower housing.
8. Replace the skimmer assembly in the scanner.
Cleaning the
separator roller
As the separator roller becomes dirty, it may begin to cause multifeeds.
To prevent feeding problems, clean the separator roller once a week or
as needed.
NOTE: Different types of documents and their condition may require
more frequent cleanings to avoid intermittent multifeeds.
1. Remove the separator roller. See the next section, “Replace the
separator roller sleeve assembly” for procedures on removing the
separator roller.
2. Clean the separator roller sleeve using a roller cleaning pad. Scrub
the roller, wiping from side to side. Repeat as necessary until the
roller is free of dust and dirt. Wipe the roller dry.
3. Avoid touching the roller sleeve (rubber material) with your fingers.
Hold the roller by the end. Wipe the roller sleeve from side to side
using a roller cleaning pad.
4. Reinstall separator roller.
To Next Page
Loading...
