26
About Your Camera
Camera Menu
Setting Options
Run Button The Run button starts/stops ilming. This
setting is the primary frame rate.
• 18 FPS (default): ~ 3 minutes, 20 seconds run
time per cartridge
• 24 FPS: ~ 2 minutes, 30 seconds run time per
cartridge
• 25 FPS: ~ 2 minutes, 24 seconds run time per
cartridge
• 36 FPS: ~ 1 minute, 40 seconds run time per
cartridge; slow motion
FPS = Frames Per Second
Function
Button
The Function button, when pressed and held
while the Run button is pressed, temporarily
changes the frame rate. This setting is the
temporary frame rate.
• 18 FPS
• 24 FPS
• 25 FPS
• 36 FPS (default)
Run Mode • Pressed (default): press and hold the run
button to shoot ilm, and release the button
to stop.
• Latched: press and release the run button to
start shooting, then press and release again
to stop.
Auto O
Mode
Auto O Mode: Camera powers o after 15
minutes of idle time. This is the default setting
which can be changed in the menu “Camera”.
This mode helps conserve power when the
camera is not in use.
• Press the Power button to turn camera on
• 5 minutes
• 15 minutes (default)
• 30 minutes
• 60 minutes
• No Audio O
Screen
Brightness
• Min
• Low
• Med (default)
• High
• Max
18 FPSRun Button
36 FPS
Pressed
5 Minutes
Med
Function Button
Run Mode
Auto O Mode
Screen Brightness
Camera
CART 3TRI-X 18 FPS
Setting Options
View Gate • Extended Super 8 (default)
• Super 8
Light Meter • On (default)
• O
Film Counter • Frames used
• Frames remaining
• % used
• % remaining
• Feet used (default)
• Feet remaining
• Meters used
• Meters remaining
Scene
Counter
• On (default)
• O
Aspect Ratio
Overlay
• O (default)
• 2.35:1
• 1.78:1/16:9
• 1.33:1/4:3
• Square
Viewinder Menu
Extended Super 8
On
Feet Used
On
O
View Gate
Light Meter
Film Counter
Scene Counter
Aspect Ratio Overlay
Viewfinder
CART 9TRI-X 18 FPS