Kodak VERITE Craft 6 - Wi-Fi Protected Setup

Wi-Fi Protected Setup
If your Wi-Fi Router has WPS function, the unit starts to connect your
Wi-Fi Router by selecting [Wi-Fi Protected Setup].
1 From the Control panel, navigate to
[Home > Setup > Wi-Fi Setup > Wi-Fi
Protected Setup], then press .
2 Press WPS button on the Router.
3 [Connected to XXXXXXXX] appears on
the Menu display, WPS (Wi-Fi Protected
Setup) is completed.
●
The XXXXXXXX represents the SSID of
your Router.
4 Press
on [Wi-Fi setup] screen.
Wi-Fi Setup
Network and Password
IP Address
Proxy
Back Select
Wi-Fi Protected Setup
Wi-Fi Protected Setup
Push WPS buon
on Wi-Fi router.
120
Cancel
Wi-Fi Protected Setup
Connected to
XXXXXXXX
Next
IP Address
1 From the Control panel, navigate to
[Home > Setup > Wi-Fi Setup > IP
Address], then press .
2 Press
to select [Auto] or
[Manual], then press
.
[Auto] DHCP (Dynamic Host
Configuration Protocol) mode
It's easy to Automatically get the IP
address of this unit from the Network.
[Manual] Static mode
Set the Network address manually.
3 If you select [Manual], set the items
below.
●
IP Address
●
Subnet Mask
●
Gateway
●
DNS
–
Press
to select [IP
Address], [Subnet Mask], [Gateway]
or [DNS], then press
.
–
Set digits one at a time. Press
to select from [0] to [9],
then press
.
–
When you enter a wrong number, then
you can correct it by pressing .
–
After you select the last digit, then press
to set IP Address and return to the
previous screen.
Wi-Fi Setup
Network and Password
Wi-Fi Protected Setup
Proxy
Back Select
IP Address
IP Address
Manual
Back Select
Auto
IP Address
Subnet Mask
Gateway
DNS
Back Select
IP Address
IP Address
Back Select
1
92 . 168 . 011 . XXX
e.g.) [IP Address] screen
54
English
Continued on next page.