Kodak VERITE Craft 6 - Wi-Fi Setup; Network and Password

Wi-Fi Setup
Select Wi-Fi Setup type and follow the Menu display instructions.
Network and Password
Wi-Fi Protected Setup
Skip
Wi-Fi Setup
OK
Note(s)
●
By factory default, the DHCP (Dynamic Configuration
Control Protocol) function is set to On, and it automatically
assigns a local IP address to your printer.
●
If you would like to set the IP address manually, refer to
below.
–
You can setup from the Menu Control Panel, then select the
[IP Address]. IP Address...Navigate to [Home > Setup > Wi-
Fi Setup > IP Address], then press
.
»
Refer to “IP Address” on page 54.
●
When performing Network connection, make sure the unit
is not placed too far away from the Access Point/Router and
the Access Point/Router is powered On and its settings are
correct.
If you need additional help on Network problems, visit our
website at www.kodakverite.com/support
Network and Password
1 If you would like to connect to a Router manually, press
to select [Network and Password], then press
.
Network and Password
Wi-Fi Protected Setup
Skip
Wi-Fi Setup
OK
2 SSID names of Routers are listed on the Menu display. Select
the SSID that you would like to connect to, then press
.
●
If the SSID that you would like to connect to is not displayed
in the list, select [Other], then press . Enter the SSID
name, then select the security type of the Router.
Router2
Router3
Router4
Network and Password
Back
OK
Select
Router1
3 [Enter Password] will appear on the Menu display, then
enter Password. Press to select a letter, then
press . After entering the Password, press
to select [Done], then press .
●
If you would like to use capital letters, numbers or symbols,
press to select [a/A/1/+], then press .
●
When you enter a wrong letter, then you can erase it by
pressing .
Network and Password
Enter Password
a bcdefghi j
kl mn o p q r s t
u v w x y z a/A/1/+
<>Done
4 Confirm the SSID name and Password displayed on the
Menu display, then press . The unit will start
connecting to the Router.
SSID: Router1
Password:
Xaxswordxssdaa123456
Network and Password
OK
Continue Back
5 [Connected to ...] message will appear on the Menu display
when the Connection is successful. Press , then the
Connection setting is completed.
Connected to
Router1
Press to print report.
Press to continue.
Network and Password
OK
OK
Continue
Print
»
Refer to “Network and Password” on page 53.
16
English
Continued on next page.