EasyManua.ls Logo

KODERA CASTING C300A - Basics》 Screen at 《Short Mode

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
《Basics》 screen at 《Short Mode》
Select 《Short Mode》 at 《Motion》 screen (P.11).
The left side roller is UP.
①《Front Strip Length》:Setting of the striping length of the front
side insulation .
②《Front Half Strip Length》:Setting of the half stripping length
of the front side.
③《Total Length》:Setting of the cutting length of the wire.
④《Rear Strip Length》:Setting of the stripping length of the rear
side insulation.
⑤《Rear Half Strip Length》:Setting of the half stripping length of
the rear side.
Explanation of the motions (In case of the sizes above)
Half Strip processing of a short
length wire can be processed at
short mode. But it might be
different from the one you
have expected.
When the length of the remaining
insulation is less than 19.9mm
Unit: 0.1m
Strip “5mm” which is “front 3mm”and “rear 2mm”
Insert the blade at the position where “Total
Length” is 20mm
Insert the blade
Move the insulation by 2mm for “rear side” and
cut
Completed
Cut
(1)
(3)
(2)
(4)
KODERA CASTING C300A - Basics》 Screen at 《Short Mode