EasyManua.ls Logo

KODERA CASTING C300A - Operation Panel; Basics》 Screen

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
4.Operation Panel
《Basics》 Screen
Standard Processing When not selecting ④~⑦ on the 《Motion》 Screen(P.11).
①《Front Strip Length》:Setting of the stripping length of the front
side insulation.
②《Front Half Strip Length》:Setting of the half stripping length of
the front side.
③《Total Length》:Setting of the cutting length of the wire.
④《Rear Strip Length》:Setting of the stripping length of the rear side
insulation.
⑤《Rear Half Strip Length》:Setting of the half stripping length of rear side.
⑥《Core Diameter》:Depth of the blade when stripping the wire. (See P,8)
⑦《Blade Move Back》:Setting of the blade back when stripping
the insulator. (See P,9)
⑧《Total Length Correction》:When “Set Total Length” and “Actually processed total length”
are different, correct it here.
0:No correction
For Example)
Set Total Length
Actual Total Length
Correctionn
Amount
○
a
1000mm
997mm
3mm
Input
3
○
b
1000mm
1005mm
-5mm
Input
-5
⑨《-》:Minus key When correcting the numerical value adversely at ⑧, use this key.
《-1》:Minus 1 key. The current number (quantity of wire to be processed) will be
reduced by -1.
⑩《Setting Pieces》:Setting of the pieces to be processed.
⑪《Current Pieces》:Processed Pieces of the wire.
During processing, number of the 《 Current Pieces 》 ( processed pieces ) is
increasing every second.
When you want to clear the displayed number to “0”, press 《Current Pieces》 [0]
[SET].
Unit: 0.1mm
Unit: 0.01mm