《Basics》 Screen at Dual striping (half stripping of outer insulation)
Select ⑦ on 《Motion》 screen （P. １１）
At above Figure, Half Strip scene is displayed so that setting becomes easily
understandable. But it is not displayed on the screen of the device.
①《Front Strip Length》：Setting of the stripping length of the front side
insulation.
②《Front Half Strip Length》：Setting of the half stripping length of
the front side outer insulation.
③Setting of the stripping length of the front side outer insulation.
④《Total Length》：Setting of the cutting length of the wire.
⑤《Rear Strip Length》：Setting of the stripping length of the rear side
insulation.
⑥《Rear Half Strip Length》：Setting of the half stripping length of
the rear side outer insulation.
⑦Setting of the stripping length of the rear side outer insulation.
⑧《Core Diameter》：Depth of the blade at A when stripping insulation.
(See P,８)
⑨《Blade Move Back》：Length of the blade’s move back at A when
striping the insulation. (See P,９)。
⑩Depth of the blade at B when stripping outer insulation. (See P,８)
⑪Length of the blade’s move back at B when stripping the outer insulation.
(See P,９)
To Next Page
Loading...