EasyManua.ls Logo

KODERA CASTING C300A - Motion》 Screen

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
《Motion》 Screen
From any screen, this screen is displayed by touching 《Motion》.
①《Motion》:It will light up when none of any optional equipment is attached.
②《Marker》:This key is set when the equipment which marks on the wire is attached. (See
P.17)
・Standard Processing:In case that any of ④~⑦ mentioned below are not set. (See P.6)
③《Short Mode》:This key is set when the length of the wire to be processed is
L-(a+b)≦19.9mm or remaining insulation is less than 19.9mm on the
picture below. 《Basics》 screen changes to 《Short Mode》. (See P.12.)
④ 《 Divide Strip 》 : When stripping can’t be performed because of the strong fixing of
insulation and core wire or long strip, it is done by dividing. 《Basic》 screen changed to
《Divide Strip》.(See P.13).
⑤《Double Strip》:When double stripping is done. 《Basic》 screen changes to 《Double
Strip》. (See P.14).
Caution:Short Mode and Double Strip are application of Half Strip processing. If the
fixing of core wire and insulation is too strong, it may not be processed just
like setting.
⑥This is set when Half Strip processing of the core wire which is doubly insulated is done.
《Basic》 Screen change to《Two-stage Strip》(See P.15)
⑦This is set when Half Strip processing of the outer insulation of the doubly insulated
wire is done. 《Motion》 screen change to 《Two-stage Strip》 (See P.16)
⑧《Initialization》: All of the data are initialized.