《Motion》 screen at 《Marker》.
Select 《Marker》 at 《Motion》 screen （P.１１）.
Set these function when you use marker.
On the above screen, all the items in marker are displayed for explanation. Depending
on the setting, items to be displayed change.
①《Both Ends Marking/Equally-Spaced Marking》：Setting how to mark on the wire which
is finished.
《Both Ends Marking》：To Mark both ends of the wire.
《Equally-Spaced Marking》：To mark on a wire more than once at even
intervals.
If none of them is selected, it does not mark.
②《Number of Specified/None Specified》《Simultaneous Marking/Asynchronous Marking》：
When 《 Both Ends Marking 》 is selected, 《 Simultaneous Marking /
Asynchronous Marking》is displayed.
When 《Equally-Spaced Marking》 is selected, display is changed to 《Number of
Specified/None Specified》.
《 Simultaneous Marking 》 ： Marking of the front and rear ends is performed
simultaneously with one marking head.
《 Asynchronous Marking》 ： Marking of the front end and rear end performed
asynchronously by operating the marking head two times.
《Number of Specified》：It marks on a wire specified times at ⑦ at even intervals.
《None Specified》：It marks on a wire by specified interval at ⑧.
③《Front Print Point》：Setting of the point to print at the front side. （distance from the
front side end of the wire.）
④《Output Time》：Input the output time of the sign to the marker
⑤《Marking Point》：Input the distance from“V blade of C300A” to the “center of the Marker
head”.
To Next Page
Loading...