KODERA CASTING C300A - Basics》 Screen at 《Divide Strip

１３
《Basics》 screen at 《Divide Strip》
Select 《Divide Strip》 at 《Motion》 screen （P. １１）.
①《Front Strip Length》：Setting of the striping length of the front side insulation.
②《Front Half Strip Length》：Setting of the half stripping length of the front side.
③Setting of the divide stripping length of the front side insulation.
：When the fixing of the insulation and core wire is too strong or stripping
length is too long, it is done by dividing.
Input each stripping length (mm) to divide.
④《Total Length》：Setting of the cutting length of the wire.
⑤《Rear Strip Length》：Setting of the stripping length of the rear side insulation.
⑥《Rear Half Strip Length》：Setting of the half stripping length of the rear side.
⑦Setting of the divide stripping length of the rear side insulation.
：When the fixing of the insulation and core wire is too strong or stripping
length is too long, it is done by dividing.
Input each stripping length (mm) to divide.
Unit:
0.1mm
Divide Strip processing
must be input at Half
Strip Length