KODERA CASTING C300A - 11．Trouble Shooting

２３
11． Trouble Shooting
Symptom
Where to check
How to repair
１）Wire is not set
automatically.
Rollers don’t rotate.
It starts processing as
soon as it starts.
The wire is fed over and
over.
２）Only front ends are not
stripped or they are
not even.
３）Only rear ends are not
stripped or they are
not even.
４ ） Both front and rear
ends are not stripped.
Isn’t it 《Short Mode》?
Isn’t the left side roller UP?
Isn’t the left side roller gap too
narrow?
Isn’t the left side roller gap too
wide? (Wire isn’t detected.）
Isn’t 《 Core Diameter 》 or
《Blade Move Back》 too large?
Isn’t the right side roller
pressure too weak?
Isn’t the stripping speed too
fast?
The right side roller is worn
away?
Isn’t the left side roller gap too
wide?
Isn’t 《 Core Diameter 》 or
《Blade Move Back》 too large?
Isn’t the left side roller
pressure too weak?
Isn’t the stripping speed too
fast?
Isn’t the left side roller gap too
wide?
The left side roller is worn
away.
Isn’t 《 Dore Diameter 》 or
《Blade Move Back》 too large?
Numerical Value is not set at
Half Strip Length？
The blade is worn away or
chipped off?
The position of the blade is out of
alignment? (When replacing
the blade)
Clear the 《Short Mode》. (See P.１１)
Make it ＤＯＷＮ.
Widen it. （ See Roller Gap
Adjustment P,９）
Narrow it down. （ See Roller Gap
Adjustment P,９））
Make 《Core Diameter》 or 《Blade
Move Back》 smaller to the proper
point.
Make the pressure stronger. （ See
P,20 「Pressure Adjustment」)
Slow down the stripping speed. (See
P,１９）
Replacement of the new roller.
Narrow it down. （ See P, ９ 「 Roller
Gap Adjustment」）
Male 《 Core Diameter》 or 《 Blade
Move Back》 smaller to the proper
point.
Make the pressure stronger.（See P,
２０「Pressure Adjustment」）
Make the stripping speed slower.
（See P,１９）
Narrow it down. （ See P, ９ 「 Roller
Gap Adjustment」）
Replacement of the new roller.
Make 《Core Diameter》 or 《Blade
Move Back》 smaller to the proper
point.
Input “０” at Half Strip Length.
Replacement of the blade.（See P,
２２）
Replace it once again.