５）All over the insulation,
both front and left ends
or core wire get
scratched.
６）The core wire is cut off.
The core wire gets
scratched.
Isn’t the roller gap too narrow?
Roller pressure of right and left
or one side or the other is too
strong?
The roller adapts to the wire?
Isn’t the 《Core Diameter》 or
《Blade Move Back》 too small?
Size of the guide pipe adapts to
the wire?
Slugs of the insulation stick to
the cutting blade and they are
cut with processed wire all
together?
The blade worn away or
chipped off?
Widen it. （ See P, ９ 「 Roller gap
adjustment」）
Turn down the pressure.（See P,２０
「Pressure Adjustment」）
Replacement of the roller which
adapts to the wire.
Make 《Core Diameter》 or 《Blade
Move Back 》 lager to the
appropriate point.
Optional replacement of the wire
guide or guide pipe which adapts to
the wire.
Set Half Strip.
Up the pressure of the air blow.
Replacement of the blade. （See P,
２２）
7 ） “Total length of the
wire which is set” and
“Actually processed
total length” are
different.
It may happen depending on
the wire because the wire is
processed by being held.
Straightening part is too strong.
Set the 《Total Length Correction》.
（See P,６）
Adjust the strength of the
straightening part（See P, ５）
8 ） On the touch panel,
touched “function” and
the function which
actually reacts are
different.
9 ） The jamming of the
wire occurs at both
front and rear ends of
the guide pipe.
Reactions of the touch panel are
out of synchronization.
Roller gap, which is the gap
between upper and lower roller,
of the left side roller is too
narrow?
The inner diameter of the guide
pipe is too small to the diameter
of the wire?
Pressing [STOP] key when the
power is ON, perform the
calibration.
Widen the roller gap. Adjust the gap
which fitｓ to the wire.（See P，９）
Replacement of the guide pipe whose
inner diameter is larger.
※ When the causes are not clear, make each speed slow on the ［Machine Adj.］ Screen. And try to
process.
You may check the troubles visually by making the speed slower.
Or select the 《Step by Step》 on the 《Machine Adj》 Screen to try to process with checking one step
by one step.
You may be able to make sure which operation has trouble.
To Next Page
Loading...