⑫《Batch Pieces》：Number of pieces to be batched. For example, you can set this when
you need 20 bundles of 50 pieces totaling 1000 pieces.
《Setting Pieces》 ［１］［０］［０］［０］［ＳＥＴ］
《Batch Pieces》 ［５］［０］［ＳＥＴ］
・ Each time the set number of batch pieces is completed, the device stops
automatically.
When it stops, press ［ＳＴＡＲＴ］ to process the number of batch pieces again.
As the processing proceeds, the display indicates the counter as follows.
1／ 50
2／ 50
3／ 50
・When you want to stop batch processing, press 《Batch Pieces》［０］［ＳＥＴ］ to cancel.
⑬Sec：By inputting the time, you can set the automatic start of the batching.
After batching the specified number of pieces, the device stops for the length of the
time specified here and then starts again automatically. Unit：second
⑭《Thin Wire》：By narrowing down the blade’s opening size, the processing speed will be
faster.
⑮《Wire Sensor》： Setting of the detection of the wire (presence of the wire) at the left roller
gap.
On the 《Motion》 screen （See P.１１）, when 《Marker》 is set, make the 《Wire
Sensor》 “OFF” （dark yellow display）.
To Next Page
Loading...