To Next Page

To Previous Page

TP-6694 9/20 27

Event Log Menu

This menu allows the user to review up to 1000 entries of system events including shutdown faults, warning faults, and status

events. See the section titled: Controller Fault Diagnostics for a list of the items that appear on the Event Log.

Volt Select Menu

Note:

The generator set must be stopped before changing the voltage selection.

This menu allows the user to readily change controller voltage settings. The volt select feature is typically used in towable or

temporary applications.

Note:

The volt select menu requires initial activation by SiteTech™ software. In SiteTech™ software, select True to activate the volt

select menu.

Note:

The generator set output leads require voltage reconnection if the generator set does not have a voltage selector switch installed.

With the generator set stopped, go to the Volt Select menu. Then push and hold the pushbutton/rotary selector dial until the

voltage selection starts to flash. Volt selection is now available. Scroll to the desired voltage and momentarily press the

pushbutton/rotary selector dial to confirm the voltage selection.

The displays for Volt Select appear as shown in the following list.

 120/240 V 1 Ph

 120/208 V 3 Ph

 139/240 V 3 Ph

 277/480 V 3 Ph

 120/240 V 3 Ph

Kohler Decision-Maker 3000 Operation

Other manuals for Kohler Decision-Maker 3000