Repair
Fuel system
Fig. 136: Connecting electrical contacts
u Connect electrical cables on the corresponding solenoid connector.
u Tighten to torque.
Specific values
Not applicable.
Tightening specifications
q Put all parts in place and tighten by hand before following the sequence.
Information
Refer to screws reuse rules. (For more information see: 5.3.2 Screws pre-tightening, reuse, and
marking, page 268.)
Fig. 137: Injector
128
© 2022 by Kohler Co. All rights reserved.
KD62V12 33525088601_8_1 EN_US
2022-09
To Next Page
Loading...
Need help?
General
