INFORMATION ABOUT REPLACEMENTS
6
51
EN
6.5 Replacement of AdBlue® filter
Warning
•
Before proceeding with operation, read Par. 3.2.2
•
Do not lubricate gaskets A with oil or fuel.
•
Filter D includes gaskets A in the package.
•
Avoid any type of contamination during replacement.
•
Before starting any operations, make sure the key on the machine’s panel is OFF and the
AdBlue® pump has executed the circuit emptying operation.
1.
Loosen cap B.
6.11
2.
Remove cap B and extract filter bracket C.
3.
Extract filter D.
4.
Use warm AdBlue® to clean the seat of filter D on
pump E if impurities are detected.
5.
Lubricate the A gaskets with AdBlue® or distilled
water.
6.
Place the filter bracket C together with filter D inside
pump E.
7.
Tighten cap B (tightening torque of 20 Nm).
6.12
To Next Page
Loading...
