4
INFORMATION ABOUT USE
EN 36
4.5 Oil filling
•
For safety precautions see Par. 2.4 .
•
Before proceeding with operation, read Par. 3.2.2 .
1.
Loosen the oil filler cap A.
2.
Add the type oil recommended ( Tab. 2.2 ).
4.1
3.
Before checking oil engine needs to be level.
4.
Remove the oil dipstick B and check that the level is up
to but does not exceed the MAX.
5.
If level is not at the MAX. level, add additional oil.
6.
Re-tighten the cap A.
Important
•
Do not use the engine with the oil level below the
minimum.
4.2
NOTE : Click on the right to play the procedure.
https://www.youtube.com/embed/
HWCzK41Br1U?rel=0
4.6 Coolant filling
•
Before
proceeding with
operation, read
Par. 3.2.2 .
NOTE: Refer to the
technical
documentation of the
vehicle.
• An anti-freeze protection liquid (ANTIFREEZE) - mixed with
decalcified water - must be used.
• The freezing point of the refrigerant mixture depends on the amount
concentration in water.
• As well as lowering the freezing point, the antifreeze also raises the
boiling point.
• A 50% mixture is recommended to ensure a general level at
protection prevents the formation of rust, galvanic currents and
calcium deposits ( Par. 2.7 ).
4.7 AdBlue filling
NOTE: Refer to the technical documentation of the vehicle.
To Next Page
Loading...
Need help?
General