For the front portion of the front frame, install the sling,
passing it through center bumper (1) as shown in the fig-
ure.
If the sling is passed through side bumper (2), the bumper
may be damaged.
6.
Fit protector blocks at contact points (3) between the lifting
tool and the dump body to prevent damage to the lifting
tool.
7.
When the machine comes off the ground (raised 100 to
200 mm), stop the lifting operation once, check carefully
that the machine is balanced and that the wire ropes are
not loose, then continue the lifting operation slowly.
OPERATION TRANSPORTATION
3-243
To Next Page
Loading...
