26.03.1996 • KHH SEENXL13A
•For Authorized KCI Service Agents Only•
KCI Hoists Corporation reserves the right to alter or amend the above information without notice
Page 36
XL
Service Manual
CU1
KCI KONECRANES GROUP
KCI HOISTS CORPORATION
14 Update the old supervisory values from the old CU1 into the new one:
a Change the CU1 into the beginning of the programming and
controlling mode by entering value 1-630 as password_1.
b Enter value 2-000 as password_2.
c Enter value 3-511 as password_3 and select function SUP5.
d Enter the SWP, Runtime, Starts and Overloads supervisory values into the
new CU1.
15 Check that the supervisory values were updated and repeat step 14 if
necessary.
To Next Page
Loading...