Konecranes CU1 - Measuring of the Running Hours (Run Time)

26.03.1996 • KHH SEENXL13A
•For Authorized KCI Service Agents Only•
KCI Hoists Corporation reserves the right to alter or amend the above information without notice
Page 9
XL
Service Manual
CU1
KCI KONECRANES GROUP
KCI HOISTS CORPORATION
8 Ready
1 SWP 1 SWP
2 Run Time 2 Run Time
8 Ready
If the zero value is reached, a negative SWP value is displayed and CU1 shifts into the
warning state and the Ready-light (and the Remote-light) starts blinking (see Figure 2).
Normal display e.g: Warning state e.g:
(zero value has been reached)
(lifting is possible, see Note 1)
(lights) (lights)
(blinks)
Remote-light (blinks; option)
Figure 2: Indications of 'SWP'.
3.2 Measuring of the running hours (Run Time)
CU1 measures and displays the number of hours the hoisting machinery has been in
operation (running up or down).
When the built-in maximum value according to the selected hoist class is reached (see
table, chapter 5) CU1 shifts into the warning state and the Ready-light (and the Remote-
light) starts blinking (see Figure3).
Normal display e.g: Warning state e.g:
(max. runtime in hoist class 1Am has been
exceeded)
(lifting is possible, see Note 1)
(lights) (lights)
(blinks)
Remote-light (blinks; option)
Figure 3. Indications of 'Running Time'.