Konecranes CU1 - APPENDIX 8: CU1 Control Page

26.03.1996 • KHH SEENXL13A
•For Authorized KCI Service Agents Only•
KCI Hoists Corporation reserves the right to alter or amend the above information without notice
Page 43
XL
Service Manual
CU1
KCI KONECRANES GROUP
KCI HOISTS CORPORATION
APPENDIX 8:
APPENDIX 8:APPENDIX 8:
APPENDIX 8: CU1 control page
CU1 control pageCU1 control page
CU1 control page (Fill in this page always before changing a
CU1)
Date and name:
Date and name:Date and name:
Date and name:
Customer:__________________________________________________________
Customer:__________________________________________________________Customer:__________________________________________________________
Customer:__________________________________________________________
Hoist type and serial number:
Hoist type and serial number:Hoist type and serial number:
Hoist type and serial number: Type:
Type: Type:
Type: No:_________
No:_________No:_________
No:_________
CU1 program version and serial number:
CU1 program version and serial number:CU1 program version and serial number:
CU1 program version and serial number: Ver P
Ver PVer P
Ver P No:
No:No:
No: _________
Valid options (read with password 1-000,
Valid options (read with password 1-000, Valid options (read with password 1-000,
Valid options (read with password 1-000, ≥ P2.12): Opt__________________
P2.12): Opt__________________ P2.12): Opt__________________
P2.12): Opt__________________
Supervisory values:
Supervisory values:Supervisory values:
Supervisory values:
SWP ________ Run Time ________ Starts ________ Overloads _______
Load sensor voltages and display with
Load sensor voltages and display withLoad sensor voltages and display with
Load sensor voltages and display with
0% load L_______/_______VDC ______% load L_______/_______VDC
Type of load sensor: Linear / Strain gauge (amplifier type: )
By using the following passwords, CU1 gives more information about the operation of the hoist:
Message logs (>P2.13)
By examing the last error messages one can easily analyze recent use of the hoist
Password 1-400 (last 10 Err-messages and corresponding STARTS values by last 4 digits)
11
22
33
44
55
Password 1-401 (total number of Err-situations)
11
22
33
44
55
Diagnostics values (see Appendix 1; password 1-113, >P2.00)
Additional Information of the use of the hoist (password 1-001 > P2.12)
Displays the
− ST-h (numbers of start per last hour)
− LSt-h (largest number of starts per hour)
− St-10 (number of starts per last 10 min) (>P2.13)
− LS-10 (largest number of starts per 10 min) (>P2.13)
− bPC ( how many times password 1-125 has been used)
− OH (how many times the hoisting motor has been overheated)
− BrFC (how many times the “brake wear sensor” has been in warning state)