Robertson AP11 Autopilot
84 20220513E
q
If a Non-Follow Up lever (or hand-held remote) is
connected, test the mode switching and verify Port and
Stbd steering commands of the lever.
q If the installation is on a sailboat, try the specific sailboat
functions using the owner as a consultant on the boats
specific steering characteristics when sailing. Be careful
to avoid hazardous situations until you gain experience.
q Set waypoints into the navigator connected to the
system, and verify that the AP11 steers in AUTO NAV
mode.
q Provide the owner with user training.
Providing user training
The user should be instructed in the "basic" operational
functions, such as:
q Turning the system on and off
q Explain how to change modes (explain briefly what
takes place in the different modes).
q Regaining manual control from any mode. Point out in
what modes the helm is engaged by the autopilot
(bypass/clutch).
q Review how to use a NFU lever and remote controller if
connected.
q Course change in 1° and 10° (TURN) increments.
q Go through the user adjustable settings and show how
to (and why) change the settings.
q Show the owner where the compass is mounted and
instruct him to keep magnetic items away.
q Show where the Mains circuit breaker is.
To Next Page
Loading...
