Instruction manual
20220513E 91
5.3 Data input check
Ru d de r
Rudder
CROSS TRACK ERROR
BEARING WP - WP
WIND APPARENT (VWR MESSAGE)
SPEED OVER GROUND
WATER SPEED
Ru dd e r
Rudde r Rudder
Rudd er Ru dder Rudder
Rudder
LOOPBACK TEST
PORT NO. 1
LOOPBACK TEST
PORT NO. 2
MODE
Each menu item will show one of the following status
codes:
--- NO DATA
OK Valid data received
INV Invalid data received
FRM Format failure, or wrong check sum received
If any of the displayed status codes are different from OK,
the most probable reason is erratic or missing data from the
data source, i.e. Nav. receiver, plotter, wind sensor or log.
Check the individual equipment for correct set-up prior to
consulting your Simrad Robertson dealer for assistance.
To Next Page
Loading...
