EasyManua.ls Logo

Kongsberg Simrad AP11 - AP11 Control Unit; J3000 X Junction Unit

Kongsberg Simrad AP11
110 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruction manual
20220513E 95
6.2 AP11 Control Unit
Power consumption: .................... 2.5 Watts max (illumination dependent)
Dimensions: mm (inches)............ 110 x 110 x 17 mm (4.3 x 4.3 X 0.7 in.)
Mounting: .................................... Flush panel mount or bracket mount (option)
Weight: ........................................ 210 grams
Display:........................................ Backlit LCD display
Size: mm (inches) ........................ 77 x 42 mm (3.0 x 1.6 in.)
Illumination................................. Adjustable in 4 steps (Off + 3 levels)
Resolution:
Top line: ...............................30 bar elements to each side
Middle line: ........................Four 7 segment characters plus direction arrows
Bottom line: ........................Eight 14 segment characters
Push buttons: .............................. Tactile silicone pads
Material: ...................................... Polycarbonate
Colour: ......................................... Black or white (optional) clip on bezel
Environmental Protection:.......... IP67
Safe distance to magnetic compass: 0.1 m
Temperature:
Operating: ...........................0 to +55°C (+32 to +130°F)
Storage: ................................–30 to +80°C (–22 to +176°F)
Alarms: ........................................ Audible and visual
6.3 J3000X Junction Unit
Input supply voltage: .................. 10 - 28 V DC
Reverse voltage protection .......... Yes
Power consumption: .................... 5 Watt (J3000X electronics)
Motor / solenoid drive:................. 6 A continuous, 10 A for 5 seconds
Output drive voltage: .................. 12/24 V DC
Proportional rate or ON/OFF (solenoids)
By-pass / clutch output: .............. 12/24 V DC 1.5 A max
Heading Sensor input: ................ Composite pulse width modulated
Rudder feedback input:............... 3400 Hz., 20 Hz/deg.
Rudder feedback units: ............... RF300 or LF/LFI3000 (optional)
ROBNET network interface:....... 3xtwisted pairs for data, supply, ON/OFF

Table of Contents

Related product manuals