Basic copy operations
3
C352 3-75
Basic copy operations Chapter 3
Stapling copies (Staple settings)
!
Detail
In order for the copies to be stapled, all of the following conditions must
be met.
- The paper width must be between 182 mm and 297 mm.
- The paper length must be between 148.5 mm and 431.8 mm.
If the “Mixed Original” setting is selected, all copies must have the same
paper width.
If a Staple setting is selected, the “Sort” setting is automatically selected.
A Staple setting cannot be used together with the “Offset” setting.
If a Staple setting is to be selected, select the orientation in which the
original is positioned and the orientation of the page to be stapled, oth-
erwise the copies may not be stapled as desired.
For details on specifying the original orientation, refer to “Selecting the
original orientation (Original Direction settings)” on page 3-23.
Copies can be fed out stapled either in the corner or at two places.
Number of Bound Pages
Examples of the possible number of bound pages are listed below.
- 50 sheets of 90 g/m
2
paper
- 2 sheets of 209 g/m
2
paper + 48 sheets of 90 g/m
2
paper
- Maximum of 30 sheets of 91 to 150 g/m
2
paper
2
Reminder
Copies can be fed out stapled either in the corner or at two places only
when the finisher is installed.
Tray Paper Weight Paper Size Loading Capacity
Finishing tray 1 50 g/m
2
to 90 g/m
2
A3 w to A5 v 32 mm
91 g/m
2
to 120 g/m
2
Finishing tray 2 50 g/m
2
to 90 g/m
2
A3 w to A5 v A4 w or less: 132 mm
B4 w or more: 64.5 mm
91 g/m
2
to 120 g/m
2
Optional finishing tray 50 g/m
2
to 90 g/m
2
A3 w to A5 v 24 mm
91 g/m
2
to 120 g/m
2
To Next Page
Loading...
Need help?
General
