12
Utility
12-64 C352
Utility Chapter 12
Adjusting the angle of punched holes
The angle of punched holes when printing with a Punch setting can be ad-
justed.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was creat-
ed.
1 Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
“Displaying the Administrator Setting screen” on page 12-47.
2 Touch [1 System Setting].
The System Setting screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5 Touch [4 Punch Resist Loop Size].
The Punch Resist Loop Size screen appears.
6 Check the angle of the punched holes.
– If the punched holes are angled, touch [+] to change the adjust-
ment. If the angle cannot be adjusted by touching [+] or if the paper
is wrinkled, touch [–] to change the adjustment.
– To scroll through the values quickly, touch [+] or [–] continuously.
To Next Page
Loading...
Need help?
General
