Konica Minolta CS-2000 - Power Switch ON( | );OFF(O); Turning power switch ON; Turning power switch OFF

23
Installation
Power Switch ON( | )/OFF(O)
The warm-up time needed is a minimum of 20 minutes in order to measure the objects
with excellent accuracy under the conditions described below. Warm up this instrument for
20 or more minutes when the power source is turned off even for a short period, and
turned on again.
(1) The object is a low-luminance light source, using 2856 K (standard light source A) as a
guide: 2 cd/m
2
or lower (1° Aperture)
50 cd/m
2
or lower (0.2° Aperture)
200 cd/m
2
or lower (0.1° Aperture)
(2) Outside room temperature and normal humidity ranges
Turning power switch ON
1. Slide power switch to ON ( | )
side.
 The measurement screen appears 5
seconds after the initial screen on the
LCD.
The model type (CS-2000 or CS-
2000A), body version and product
serial numbers are displayed on the
initial screen. The model type can be
also confirmed on the nameplate.
Turning power switch OFF
2. Slide power switch to OFF (O
side) after measurement.