73
Communication
Remote Mode
Remote mode refers to sending command from PC to this instrument with both connected.
If this instrument is controlled with PC, “REMOTE MODE” appears on the LCD. While
this message is displayed, key operation of this instrument is not acceptable except
for following cases.
If the measurement button is pressed, measurement starts to forward the data to
PC. (in case that measurement button is in valid mode by transferring command
from PC to this instrument. Use data management software below.)
When
ESC
key is pressed, the remote mode is canceled.
To control this instrument with PC, use the data management software CS-S10w
Professional in the standard accessories. See instruction manual of CS-S10w Professional
for details on the specifications and usage.
If you want to use an independent program on PC to control this instrument, download
Communication Specifications from KONICA MINOLTA’s website at URL below for your
reference
http://konicaminolta.com/instruments/download/software/index.html
(The above URL is subject to change without notice.)
(If the target page will not appear, please search the site by keywords, CS-2000 and
download.)
ESC
Key
LCD screen
Measurement button
To Next Page
Loading...
Need help?
General
