Safety Instructions
Please read the safety instructions carefully before get started.
ANYCUBIC 3D printer generates high temperature. Do not reach
inside of the printer during operation. Allow time for the printer to
cool down after printing. Contact with the extruded material may
cause burns. Wait for printed objects to cool before removing them
from the build platform.
ANYCUBIC 3D printer includes moving parts that can cause injury.
Vapors or fumes may be irritating at operating temperature. Always
use the ANYCUBIC 3D printer in an open, well ventilated area.
Be cautious when using the scraper. Never direct the scraper
towards your hand.
The ANYCUBIC 3D printer MUST NOT be exposed to water or rain.
The ANYCUBIC 3D printer is designed to be used within ambient
temperature ranging 8ºC-40ºC, and humidity ranging 20%-50%.
Working outside those limits may result in low quality printing.
In case of emergency, immediately turn off the ANYCUBIC 3D
printer.
It is recommended to use protection glasses when cleaning/sanding
printed models to avoid small particles contacting eyes.
Never leave the ANYCUBIC 3D printer unattended during operation.
To Next Page
Loading...
