Shenzhen Anycubic Technology Co., Ltd.
5
Fig. 10
3. Slide guide (Linear and Pulley)
The operation of effector depends on the linear motion of each belt which is connected to
stepper motor. The type of motion guide is divided into Linear and Pulley. The assembly of
those two types will be introduced in the following section.
First of all, find 3 pieces of long Al-extrusions and fix them from the upper side to the bottom
triangle as shown in Fig. 11. If choose the wrong side, the Al-extrusion would not fit in. Next,
tighten the corresponding screws at each corner which is shown by red arrows.
Fig. 11
The following section is interpreted based on two different types, Linear and Pulley.
(1) Linear Version
Step 1. Firstly, hang 6 pairs of C06 and C10 with proper interval onto the linear rail (D06)
as demonstrated in Fig. 12. In total there are 3 rails and the assembly is the same.
To Next Page
Loading...
