Kramer DSP-62-AEC

Kramer Electronics Ltd.
DSP-62-AEC, DSP-62-UC – Technical Specifications
54
Default Communication Parameters
RS-232 Control/Protocol 3000
Baud Rate:
115,200
Data Bits:
8
Stop Bits:
1
Parity:
None
Command Format:
ASCII
Example (adjust analog audio output 1 to “-10dB”):
#x-aud-lvl out.analog_audio.1.audio.1,-10
Ethernet
To reset the IP settings to the factory reset values go to: Menu->Setup -> Factory Reset-> press Enter to
confirm
Note that the device is configured as DHCP ON mode, so in a network where the device receives an
automatic IP, the device is accessible via its name or the IP it received.
IP Address:
192.168.1.39
Subnet mask:
255.255.255.0
Default gateway:
192.168.0.1
UDP Port #:
50000
TCP Port #:
5000
Default username:
Admin
Default password:
Admin
Full Factory Reset
Recessed Button
Press and hold while powering the device.
Protocol 3000:
“#factory” and #Reset commands.
Webpages:
In the Settings page, click Reset.
Default EDID for DSP-62-AEC
Monitor
Model name............... DSP-62-AEC
Manufacturer............. KMR
Plug and Play ID......... KMR1200
Serial number............ 295-883450100
Manufacture date......... 2018, ISO week 255
Filter driver............ None
-------------------------
EDID revision............ 1.3
Input signal type........ Digital
Color bit depth.......... Undefined
Display type............. Monochrome/grayscale
Screen size.............. 520 x 320 mm (24.0 in)
Power management......... Standby, Suspend, Active off/sleep
Extension blocs.......... 1 (CEA/CTA-EXT)
-------------------------
DDC/CI................... n/a
Color characteristics
Default color space...... Non-sRGB
Display gamma............ 2.20
Red chromaticity......... Rx 0.674 - Ry 0.319
Green chromaticity....... Gx 0.188 - Gy 0.706
Blue chromaticity........ Bx 0.148 - By 0.064
White point (default).... Wx 0.313 - Wy 0.329
Additional descriptors... None
Timing characteristics
Horizontal scan range.... 30-83kHz
Vertical scan range...... 56-76Hz
Video bandwidth.......... 170MHz
CVT standard............. Not supported
GTF standard............. Not supported
Additional descriptors... None
Preferred timing......... Yes
Native/preferred timing.. 1920x1080p at 60Hz (16:9)
Modeline............... "1920x1080" 148.500 1920 2008 2052 2200 1080 1084 1089 1125 +hsync +vsync
Standard timings supported
720 x 400p at 70Hz - IBM VGA