Figure 33: Processing View – AEC Module
3. Click Enable to apply AEC to the signal.
AEC is enabled.
Using Delay Module
Set the delay to accommodate the audio to the listeners distance from the speakers. Delay
time tool converts the delay in milliseconds to meters, feet, and samples.
To adjust the delay:
1. In the Navigation pane, click DSP. The DSP (Main) page appears.
2. Click Delay. The button turns green and the Equalizer processing page appears.
3. Click the Off button . The Delay module turns on .
Figure 34: Processing View – Delay Module
4. Set the delay.
Delay setting is adjusted.
To Next Page
Loading...
Need help?
General
