Kramer VP-724xl

Connecting your Presentation Switcher / Scaler
11
P
R
E
L
I
M
I
N
A
R
Y
5 Connecting your Presentation Switcher / Scaler
To connect the VP-724xl for example
1
(see Figure 9), do the following
2
:
1. Connect one or more of the following video sources:
 2 composite video sources: “AV Source 1” and “AV Source 2”, to the
RCA connectors AV1 and AV2, respectively
 2 s-Video sources: “s-Video Source 1” and “s-Video Source 2”, to the 4p
connectors, YC1 and YC2, respectively
 A component video
3
source, for example, a “Betacam VCR”, to the 3
RCA connectors, Y, P
b/
C
b
, and P
r/
C
r
4
 2 VGA graphics sources
5
: “VGA Graphics Source 1” and “VGA Graphics
Source 2”, to the HD15 connectors VGA 1 and VGA 2, respectively
 A DVI graphics source, to the DVI connector
2. Connect the stereo audio sources
6
(not illustrated in Figure 9):
 The audio of “CV Source 1” and “CV Source 2” to the AUDIO IN AV1
and AV2 terminal block connectors, respectively
 The audio of “s-Video 1” and “s-Video 2” to the AUDIO IN YC1 and
YC2 terminal block connectors, respectively
 The audio of the component video source, the “Betacam VCR”, to the
AUDIO IN COMP terminal block connector
 The audio of the “DVI Graphics Source ” to the AUDIO IN DVI terminal
block connector
 The audio of “VGA Graphics Source 1” and “VGA Graphics Source 2” to
the AUDIO IN VGA1 and VGA 2 terminal block connectors, respectively
3. Connect the “VIDEO OUT 1” and “VIDEO OUT 2” HD15F connectors
7
to the video acceptors, for example, a Plasma monitor and a VGA
monitor.
1 From this section on, all the information is relevant to the VP-719xl, VP-720xl, VP-723xl and VP-724xl machines, unless
noted otherwise
2 Switch OFF the power on each device before connecting it to your VP-724xl. After connecting your VP-724xl, switch on its
power and then switch on the power on each device
3 Sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb, Pr
4 Alternatively, you can connect an RGB signal (not shown in Figure 9), as follows: Red to the Y connector, Green to the
Pb/Cb connector, and Blue to the Pr/Cr connector
5
Available only on the VP-724xl, other models in this series have only one VGA graphic source
6 As required. Not all devices need to be connected
7 In the HDTV mode, the signal goes out via 3 PINS: PIN 1 is Red or Pr, PIN 2 is Green or Y, PIN 3 is Blue or Pb