7.5.7 Choosing the Output Utility Settings
Figure 37 and Table 14 define the Output Utility settings. From the Output
Setting Utility screen, you can set the Resolution, Refresh Rate, and a user
definable output mode (see Figure 39 and Table 15).
Figure 37: Output Setting Utility Screen
Table 14: Output Setting Utility Screen Features
Button Function
Resolution Select the desired resolution from the list, including the User Define resolution
(for advanced users only)
You can cycle the output resolutions (choosing the pixel resolution) by
pressing the OUT key on the infra-red remote control transmitter (see Figure
16). The OSD status appears superimposed over the top right corner of the
screen for a few seconds
1
, as Figure 38 illustrates
2
Refresh Rate Select the refresh rate: 60Hz, 75Hz, 85Hz or 50Hz
Confirm / Discard Select to confirm or reject Resolution and Refresh Rate selections
User Mode Setting Set a user definable output mode
3
(see Figure 39)
Output Mode
800x600 75Hz
Figure 38: OSD Output Status
1 By default, 20 seconds. But you can reset the timeout (from 3 to 60 seconds)
2 Adjusting the output resolution results in a corresponding adjustment to the size of the OSD status window
3 Recommended for advanced users only – non-standard settings may not be recognized by the display device
To Next Page
Loading...
