6.2.4 Toggling between the PIP and the Screen Source (SWAP)
To toggle back and forth between the PIP Source and the main display, do the
following:
Press the SWAP key on the infra-red remote control transmitter (see
Figure 16)
The OSD SWAP status appears superimposed over the top right corner of the
screen for a few seconds
1
only when the Source Prompt is ON, as Figure 13
illustrates.
Auto(NTSC System)
PIP : YC-1
SWAP
Main: YC-1
PIP : DVI
Figure 13: OSD SWAP Status
6.2.5 PIP Characteristics
You can determine the following PIP characteristics:
The PIP Size (1/4, 1/9, 1/16, 1/25, Split or User Define)
The Horizontal and Vertical position, letting you place the PIP anywhere on the
screen
1
By default, 20 seconds. But you can reset the timeout (from 3 to 60 seconds), see
section 7.5.6
To Next Page
Loading...
