Kramer WP-5VH2

WP-5VH2 - Operating the WP-5VH2 Remotely Using the Embedded Web Pages
29
29
Note: The display is not updated automatically when the status of an EDID
changes on the device caused by outputs being exchanged. Click Refresh to
update the display, (see item 11 in the following table).
#
Item
Description
1
Read
from Area
DEFAULT
EDID button
Click to read the default EDID
2
Output 1 button
Click to read the EDID from output 1
3
Input 1 button
Click to read the EDID from input 1 (HDMI)
4
Input 2 button
Click to read the EDID from input 2 (VGA)
5
BROWSE
button
Click to open the file browser to select an EDID
file on your computer
6
Short Summary Information
Area
Displays the current election of EDID source,
destination, video resolution, audio availability,
and status
7
Copy to
Area
Inputs selection
box
Check to select both inputs
8
Lock button
Locks the EDID on the currently selected input
9
Input 1 button
Click to select input 1 as the destination (HDMI)
10
Input 2 button
Click to select input 2 as the destination (VGA)
11
COPY Button
Click to copy the EDID from the selected source
to the selected destination
12
Refresh Button
Click to refresh the display
To copy EDID data from a source to one or both inputs:
1. Click the source button from which to read the EDID (default, output, input,
or EDID file).
The button changes color and the EDID summary information reflects the
selection and EDID data.
2. Click a destination input, or select both inputs by checking the Inputs check-
box.
All selected input buttons change color and the EDID summary information
reflects the selection and EDID data.
3. Click the Copy button.
The “EDID was copied” success message is displayed and the EDID data is
copied to the selected input(s).
4. Click OK.