Krell Industries Showcase - Page 63

Krell Showcase Processor 59
System Configuration, continued
Bass Peak Limiter Setup
Screen
When you select ON, the BASS PEAK LEVEL reverts to 0. Use the up
direction key to increase the output of the noise generator. Select the
volume level limit (0-90) by increasing the noise generator until the
bass sounds distorted. Then set your selection at that level, or slightly
below.
After setting your selections, press the previous key (74) once to
return to the
OPERATION screen.
SHOWCASE
-BASS PEAK LIMITER SETUP-
 OFF 
N/A
BASS PEAK LIMITER
BASS PEAK LEVEL
The BASS PEAK LIMITER SETUP menu lets you turn the bass peak limiter
option
ON or OFF. When this option is ON, you can then set the maxi-
mum amount of .1 (or LFE) and redirected bass that is sent to your
subwoofer. If you do not have a subwoofer, this option limits the max-
imum amount of 1 (or LFE) and redirected bass that is sent to your
full range front and/or surround loudspeakers.
Select
BASS PEAK LIMITER SETUP from the OPERATION menu. The BASS
PEAK LIMITER SETUP screen appears,, with the cursor blinking at OFF:
Bass Peak Limiter Setup