Krell Industries Showcase - Placement and Power Guidelines; Installation and AC Power

Krell Showcase Processor 5
Before you install the Showcase Processor into your system, review
the following guidelines to choose the location for the component.
This will facilitate a clean, trouble-free installation.
The Showcase Processor does not require any type of special rack
or cabinet for installation. For the dimensions of your Showcase
Processor see Specifications, on pages 76-77.
The Showcase Processor requires at least two inches (5 cm) of
clearance on each side and at least two inches (5 cm) of clearance
above and below the component to provide adequate ventilation. In
addition, the Showcase Processor requires at least three inches
(7 cm) of clearance between other connected components. For
installations inside cabinetry, extra ventilation may be necessary.
The Showcase Processor has superb regulation and does not
require a dedicated AC circuit. Avoid connections through extension
cords or multiple AC adapters. High quality 15 amp grounded AC
strips are acceptable.
High quality AC line conditioners or filters may be used if they are
grounded and meet or exceed the unit’s power supply rating of 100
VA. Contact your authorized Krell dealer, distributor, or Krell before
using any devices designed to alter or stabilize the AC power for the
Showcase Processor.
The Showcase Processor should be used only with the power cord
supplied.
Placement
AC POWER
GUIDELINES