Krone EASYCOLLECT 9000 - Default Chapter; Table of Contents

Contents
Contents
1 General aspects................................................................................ I -1
1.1 Intended use............................................................................................................. I -1
1.2 Technical data .......................................................................................................... I -1
1.2.1 General aspects ...................................................................................................... I -1
1.2.2 Address of the manufacturer.................................................................................... I -1
1.2.3 Declaration .............................................................................................................. I -1
1.2.4 Designation ............................................................................................................. I -1
1.2.5 Information for enquiries and orders ........................................................................ I -1
1.2.6 Intended use............................................................................................................ I -2
1.2.7 Technical data ......................................................................................................... I -2
2 Safety................................................................................................ IV -1
2.1 Identifying important information in the operating instructions .................................. IV -1
2.2 Safety instructions and accident prevention regulations .......................................... IV -1
2.2.1 Personnel qualification and training ...................................................................... IV -1
2.2.2 Dangers in failure to comply with the safety instructions ....................................... IV -1
2.2.3 Safety-conscious work practices ........................................................................... IV -1
2.2.4 Safety and accident prevention regulations........................................................... IV -2
2.2.5 Attached devices ................................................................................................... IV -3
2.2.6 PTO operation ....................................................................................................... IV -3
2.2.7 Hydraulic system ................................................................................................... IV -3
2.2.8 Maintenance.......................................................................................................... IV -4
2.2.9 Unauthorised conversion/modification and Manufacture of spare parts ................ IV -4
2.2.10 Impermissible modes of operation......................................................................... IV -4
2.3 Safety instructions on the machine.......................................................................... IV -5
2.3.1 Location of the warning pictograms on the machine. ............................................. IV -6
2.3.2 Location of the general warning signs on the machine.......................................... IV -8
3 Start-up............................................................................................. III -1
3.1 Special safety instructions ....................................................................................... III -1
3.2 Stop points .............................................................................................................. III -1
3.3 Storage ................................................................................................................... III -1
3.4 Attaching ................................................................................................................. III -2
3.4.1 Adjusting the adapter frame................................................................................... III -2
3.4.2 Pendulum frame .................................................................................................... III -3
3.4.3 Coupling................................................................................................................ III -3
3.5 Transport position.................................................................................................... III -5
3.5.1 Folding in the tubular bar on the right/left .............................................................. III -5
3.5.2 Swinging the maize header up .............................................................................. III -5
3.5.3 Parking supports in transport position on the right/left ........................................... III -6
3.5.4 Installing guard on the right/left.............................................................................. III -6
3.5.5 Connecting indicators and position lights on the right/left...................................... III -6
3.5.6 Installing the front guard ........................................................................................ III -7
3.5.7 Road travel ............................................................................................................ III -7
3.6 Working position ..................................................................................................... III -7
3.6.1 Removing the protective cover .............................................................................. III -7
3.6.2 Adjusting skids ...................................................................................................... III -7
3.6.3 Folding up the tubular bar on the right/left ............................................................. III -8
3.6.4 Adjusting the plant dividers ................................................................................... III -8