III - 12
Start-up
The system should be without
pressure on both sides when
disconnecting the hydraulic hoses (1).
• Disconnect the hydraulic lines (1) at the hydraulic
couplings and close off with dust caps.
• Pull off the lighting cable (2).
• Loosen the connection cable (3) of the sensors.
Danger of accident and damage!
Place hydraulic hoses and electrical
connection cable on the maize header.
• Open the protective cover (3).
.
• Pull the joint fork (1) off of the drive journal (2) of the
main angular gear.
• Open the locking hook (1):
Remove the spring cotter pin (3), pull the locking
lever (2) from the locking pin (4) and swing it
forward.
• Lower the pendulum frame of the forage harvester
until the receiving claws are below the holding bolts.
• Move the forage harvester back.
To Next Page
Loading...
