Krone EasyCut 7540 - Page 42

Driving and Transport
42
Pos: 17.8 /BA/Fa hren und Transp ort/EasyCut/F ahren-Transport Bild EC 7540/914 0@ 11\mod_122 3386858860_78.d oc @ 146016
1
4
2
3
EC800038
Fig. 16
Pos: 17.9 /BA/Fa hren und Transp ort/EasyCut/F ahren/Transport Te xt mit Absperr hahn EC 7540/9 140 @ 11\mod _122338693067 3_78.doc @ 14 6038
For transport/road travel, the disc mower units must be folded upward.
To do this:
• Switch off PTO drive.
• Swivel the parking supports into transport position and lock it into position with the bolts
(see chapter on start-up entitled "Swivelling the parking support into transport position").
• Move the flip switch (2) to the "Down" position (see chapter on operation "Function of
switches on the control unit").
• Move the flip switch (3) to the "Middle" position (see chapter on operation "Function of
switches on the control unit").
• Activate the single-action control device (1) (red 1) to raise the mowing units slowly from
the working position to the headland position.
• Move the flip switch (2) to the "Up" position (see chapter on operation "Function of
switches on the control unit").
• Activate the single-action control device (red 1) to raise the mowing units from the
headland position to the transport position.
• Switch off the control unit.
• Close the shut-off valve (1).
• Raise the right and left parking supports for transport/road travel and lock them in place
with the bolt (see chapter on Operation "Parking support").
• Swivel the parking back for the transport/road travel and lock it in place with the bolt (see
chapter on Operation "Parking Support").
Pos: 17.10 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65