Maintenance
76
Pos: 25.29.1 /Üb erschriften/Üb erschriften 2/K-O/ Ölstandskontroll e und Ölwechs ela m Mähhol m @ 0\mod_11 97017549815_78. doc @ 15963
10.9 Oil level check and oil change on the cutter bar
Pos: 25.29.2 /Üb erschriften/Üb erschriften 3/K-O/ Ölwechsel @ 0 \mod_1197021 941955_78.doc @ 16139
10.9.1 Oil change
Pos: 25.29.3 /B A/Wartung/Mäh werke/Hinweis Ei n Ölwechsel amMä hholm ist nicht erforderlich. @ 68\ mod_1304577 391388_78.doc @ 628708
Note
No oil change is required on the cutter bar.
Pos: 25.29.4 /Üb erschriften/Üb erschriften 3/K-O/ Ölkontrolle @ 0\mod_11970219 08190_78.doc @ 16120
10.9.2 Checking the oil level
Pos: 25.29.5 /B A/Sicherheit/Gefa hrenhinweise/Mä hwerke/Schnell r otierende Me sserteller/Messertr ommel_2 @ 0\mod_119702 2569252_78.doc @ 16165
Danger! - Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
Lower guards. Nobody should be in the danger zone around the machine.
Pos: 25.29.6 /B A/Sicherheit/Gefa hrenhinweise/Mä hwerke/Schnell r otierende Me sserteller/Messertr ommeln_1 @ 0\mod_11970 17696736_78.doc @ 16001
Danger! - Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
• Switch off the engine and remove the ignition key.
• The cutting discs/blade drums continue to run!
• Do not leave the driver’s cab until the cutting discs/blade drums have come to a complete
stop.
Pos: 25.29.7 /B A/Wartung/Mäh werke/Ölkontrolle M ähholm Easycu t EC 280/320 @ 9\mod_12210 47992481_78.d oc @ 131607
EC-0-003
Fig. 42
• Allow the machine to run briefly.
• Wait until cutting discs/blade drums have come to a complete stop.
• Move the cutter bar into transport position.
Check the oil level before every use
• Remove the oil level inspection screw (1) from the cutter bar.
• The oil level must be up to the bore hole. If required, top up the oil (SAE 90)
• Screw in the oil level inspection screw (1) again and tighten securely.
Pos: 25.30 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
